1995 Dodge Caravan "replace crank sensor" Questions

...sensor so replaced distributor. Still won't start. Motor will not even turn. What is wrong? Are you saying the engine will not crank, or crank but will not start ? None of the engine sensors ...

replace 2 sensors the cam and crank at the same time. You want to go directly to Napa or Dealer. After market brands a set 1 point higher. They are in expensive. The crank sensor is easy to change the

...not start replaced crank sensor and cam sensor still missing popping back like bad value What codes did you have that led you to replace these parts and what testing and diagnosis did you

...crank correlation sensor!! coil/wires/ plugs are new. I am getting some red fire but no blue fire.HELP Is there a sensor between these two or is it the computer, dont think so or the scanner would ...

... crank sensor needs to be replaced. 95% other 5% hmmm wiring problem on / near crank or cam sensors, theft system active, dead pcm....... Where is the Crank Sensor located in a 2003 Dodge Caravan ...

crank sensor go in and out of sink no start timing chain and gears have been replaced and both sensors no codes Cam and crank sensors both have to be gapped. A couple pieces of masking tape on the end

i need to know if the crank angle and cam shaft sensors are two d we had our crank angle sensor replaced but car stills stalls... yes each one has its own sensor.

...crank sensor out of the transmission/engine? It has a magnetic pick up that reads off of the ring on the flywheel. This sensor is adjustable so take care when removing to see if it was cracked .When ...

If no spark, check to make sure the distributor is turning(if applicable) If a 3.3 motor with no spark, suspect the crank sensor or cam sensor. Crank sensor is much easier to replace if experimenting

No signal from crank or cam sensor If you are not getting a signal form your crank sensor or your cam sensor they are bad and need to be replaced.