2005 Chevrolet Aveo "bad hold light chevy" Questions

Hold light flash only after 30 mph will not come on if the speed is kept under that and tried raising car off ground and drove to 80 mph no lights and tried pressing brakes to simulate load no problem

...bad (cylinder 3) All four need to be replaced at once. After replacing the coil pack and plugs the check engine light went out and the hold light went out. This was an extremely easy repair. I walked ...

...bad. if hold is never used at all (what good is it IDK) Id even disconnect the switch and see it hold shuts off the switch is 2 pins, SPST switch, and open or shorted pins is the goal , the cluster ...

...HOLD SWITCH. Also the car going from warm when you drive then cold when you park it at night. My car was in warranty and remind you I came up with is the dealership had no idea what was wrong. they ...

...bad master cylinder though. Your problem is that the brake fluid is leaking out the back of the master cylnder, and getting sucked into the brake booster.You will probably need a new master cylnder ...

...and singles bad turn signal switch broken inside switch, need to remove steering wheel, remove clip, unplug connector under dash on column, undo the 3 screws hold switch in, install in reverse

...low beams stopped working. high beam wont stay unless i hold the switch. can i use an old school floor switch for the high beams? I would say your light switch is either dirty or bad. ...

...hold the lever down slightly. If I pull the lever down to the lock position, it does not blink or light up on the instrument panel and the rear lights stay lit and do not flash. Is this problem the ...

...hold brake pedal to start but it will not today. Probably your starter has gone bad. You could try jumping it, you might have a bad battery, any clicking or anything when you try to start it? Lights ...

...bad oil sending unit. which light the oil change light if this is the case u can reset it by leaving ur ignition n the run position but car not on and hold the odometer reset button til the light ...