Question about Mitsubishi Mirage
98 elantra 2.0 1.8 l... i need timing marks for 98 elantra 2.0 1.8 l the camshaft is the dot on the sprocket there is a small mark behind it on the cover 12 oclock the crank there is a mark on it look
Question about Mitsubishi Mirage
...98 dodge neon 11= Timing belt skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine ...
...sensor and the time to clean the throttle body, on a 98 jeep cherokee sport 6 cylinder,4 liter? thanks glenn Its about 1/2 hour job max on the sensor.To replace the t/body is a 1 hour
...98 malibue v 6 here you go Fig. Align the timing mark on the crank sprocket (2) to the mark on the bottom of the timing chain damper (1) and the timing mark on the cam gear (4) to the mark on the top ...
98 toyota tacoma v6 4wd 3.4l eng. I took the timing belt off without marking the pulleys, and looking in the manual can i just line of the marks on the pulley with the marks on the block? and by doing
...98 cavalier 2.2 1998 Chevrolet Cavalier 2.2L SFI OHV 4cyl Fig. 1: The timing marks on the sprockets should be in alignment. If not, turn the crankshaft until the marks are aligned Fig. 2: The timing ...
...98 chevy truck You will need to put it into base timing mode, should be a tan and white wire on firewall near distributor, then with a timing light you can set the timing, after you have set cylinder ...
...98 acura hesitates same times at 40 mls./hour or 60ml/h. check engine light cod: PO171 System too lean (bank 1) PO170 Fuel trim malfunction (bank 1) Clean the MAF sensor with CRC brans MAF spray ...
...98 Hi: 1st thing to do is pull #1 Spark Plug AND before you Crank The Engine PULL COIL WIRE so your car does'nt Start During Your ommpression Test.Once you have commpression coming out #1 Spark ...
203 questions posted
Usually answered in minutes!
236 Questions
221 Questions
156 Questions
182 Questions
132 Questions