2006 Chevrolet Colorado "replace blower resistor" Questions

...replace the Resistor Module 3 times in 140K Miles and the Blower motor twice. Michigan Winters are COLD and Summers are Warm requiring the A/C normally on High Blower speed. Let me know what you ...

...resistor as you correctly diagnosed, but the new resistor is blown because the fan motor is drawing to much current and blowing the resistor back out, replace the blower motor and resistor

...replace the blower resistor pack, replace the wire harness to since they are also known to go bad from the heat created from the electrical current which mad your resistor pack go bad. Good luck and ...

...blower motor resistor is bad,thats what controls the speeds. replace that and your fan should work just fine, good luck. Check the blower resistor to see if its bad, next check the switch, then check ...

...blower motor connectors and terminals. If you see signs of overheating, you need to repair or replace the whole connector. On some models, there is an issue of missing thermal gaskets placed between ...

...blower motor. These tend to burn out. You can buy them at the auto parts store for about 30 bucks. I just replaced the one on my 05 sierra I had the same problem with mine, after going through 3 ...

...high speed only Hello whiterich970, The most common solution to this is to replace the blower motor resistor. Below is an image depicting the location of the resistor. I hope this helps. Regards, ...

...blower motor resistor and connector located under the pass. side of the dash need replaced the connector melts and burns the resistor an updated part is available from the dealer I have replaced many ...

...blower motor resistor was replaced, make sure all connections are tight and well plugged in. I would supply direct powerr and ground to the blower motor to see if it works. It still sounds like a ...

...blower doesn't work on any speed. It worked fine before, but now it doesn't. However, it's not a hard fix. Here's a link to a site with a write-up on how to replace the resistor pack as well as the ...