...water pump is going to be one of the pulleys on the serpintine belt. its going to be the only one that uses the back of the belt(side with no groves) to spin it. take the belt off and undo the three ...
...replaced recently making grinding noise overheating with belt wobbling. Where do I start? Possible water pump. Remove the belt and grab the pulley , wiggle and spin. Check the other pulleys as
...belt spins: a/c compressor, idler pulley, belt tensioner, and yes your water pump or power steering pump. How do u know the ps. pump is ok? Did u remove the belt and spin the pulley by hand? That ...
Question about Cars & Trucks
...belt! The water pump pulley is seized and therefore not allow the AC pulley to move the water pump is going bad should have a little resistance --with the a/c clutch pulley the pulley is two parted ...
...driven accessories The power steering belt runs off the crankshaft pulley and then turns the power steering pump and water pump, this belt is needed to spin the water pump or engine will overheat
Question about Mazda Cars & Trucks
...water pump and belt, still squealing When you replaced the water pump did you check the bearings on the other pulleys? A lot of times when a pump goes out it will cause the belt to overheat and will ...
water pump and back to the ps pump. best bottom (grooved area) should match with any pulley with grooves, back of belt should contact smooth pulleys. 9example...grooved part contacts ps pulley, smooth
Question about Dodge Cars & Trucks
...belt, (ribbed to ribbed or smooth to smooth). It could also be that it's the wrong pump for that engine. Not all water pumps spin in the same direction. Check the pump you have is the correct one for ...
...belt can it cause the water pump not to pump enough water and make the car overheat? also how do you change the tensioner pulley. i read where it says to insert a socket wrench in the square hole on ...
...spins while trying to loosen bolts connecting pulley to water pump. a flat bar or screwdriver can be put across 2 bolts for leverage or wrap belt around pulley and pull tight for tension on pulley ...
671 questions posted
Usually answered in minutes!
757 Questions
631 Questions
489 Questions
426 Questions
352 Questions