2000 Buick LeSabre "put gear" Questions

put back in drive and will only go in low gear I take it the shifter will work at all selections made. The problem pertains to the automatic shifting inside the hydralic pump only which a transmission

put it in gear, if ready to go again, after one minute, it is unengage again. If this is the case the torque convertor clutch solenoid will need replacement. You can buy some time by disconnecting it.

...put the car in any gears the leaver just goes up and down Your gear selector cable is broken somewhere between the the selector itself to the transmission..it's not hard to check,just have somebody ...

...gear and works fine it is worse when 1st started morning Check your transmission fluid level. By putting it into gear at high RPM, you're forcing it and may be really damaging your transmission. ...

...and gasket, replaced fluid. same problem. today had fluid flushed. asked for mercon 5 mechanic put dextran and put an additive, claimed that brings it up to standards of mercon 5. Result is car ...

...put into gear could be a couple of things because when u put a car in gear the idle goes down so check see if it dies while ur sligthly on the gas to keep it running but be carefull.if the car dies ...

...put in gear separate circuit from headlight switch. You probably have a bad multifunction switch. Thats the switch with your headlights, turn signals, cruise control, etc... Have it checked by a shop ...

can't put the car in any gears can't put the car in any gears shift cable broken or the shift lock solenoid or the brake pedal switch that releases the shifter as louser suggest the cables

gear shifter in my 91 buick lesabre broke wont put the car in gear it just slides up and down shoulds like the trans cable came loose or broke wouls suggest taking into a repair shop

put the car into gear it won't click into gear for a few seconds. when the car is in over drive on the freeway i have to put it into drive because it sputters. your transmission oil is most likely