2006 Mazda 6 "6 light" Questions

6 sport sedan break lights not working after hid light conversion Tail lights work fine but when I press break pedal the lights just stay the same Instructions Open the rear deck lid on the Mazda

...6 tail light The tail-light must then be carefully pulled/slid outwards. Notice how the end of the tail-light . Remove the two plugs attached to the tail-light using the needle nose pliers and place ...

...6 2001, Ibs light and handbrake warning light keep coming on when im driving what could be wrong with this car? Check brake fluid level.  If fluid level is low, it can cause lights to flicker on ...

...6 reverse lights i cannot get reverse lights to work checked bulbs and fuses ITS POSSIBLE THAT YOUR REVERSE LIGHT SWITCH IS FAULTY BEST WAY TO FIND OUT IS TO DISCONNECT REVERSE SWITCH AT G/BOX & ...

6 AT light = hard clunk putting it into gear I have a 2004 Mazda 6, and lately it makes a hard clunk sound when I put it into gear, but only when the AT dashboard light is on. The light comes and goes

...6 3.0 dohc ... low beams and fogs dont work. High beams work. checked fuses and all is well. new silverstar headlights put in about a month ago. Light symbols are registering inside car( fog light, ...

...LIGHTS I would like to know the maximum intensity of HID lights that I can install in a 2004 mazda 6 car. normally it depends which state you drive in. some allow only a maximum of 65/55watts. its ...

...6, the front passager side only, lights do not work. But the blinker still works, why? so you mean the signal works at the very front or the side light bulb(on the side of the lens assembly) that is ...

...6 oil light came on added oil light still on could this be the oil pump My oil light came on in my 2005 Mazda 6 I added oil and light is still on. Could the oil pump be going bad? The oil light means ...

2006 Mazda 6 front parking lights I cannot figure out how to change the front park light bulb. http://forum.mazda6club.com/electrical/135367-changing-194s-headlights.html