2005 GMC Sierra "fan blower resistor keeps burning" Questions

...fan does not work on setting 5. it does work on all other settings The switch or the wire harness at the blower motor has gone bad. The highest setting 5 has no resistor, so the blower runs on high ...

...blower fan resistor, and now the blower motor quit. Is there something wrong with the temperature control? The problem was the motor. Replace the blower motor and resister and it should be fine. If ...

...blower fan switch only has a high. As soon as I turn it on it goes to high. Would this also be the relay? this sounds like a bad blower motor resistor board that has gone bad. they are designed to ...

...blower motor would it be a bad ground and where do I look? Truck has a few other electrical problems Check the alternator output voltage. It sounds like the voltage regulator is bad. A bad ground ...

...fan will only work on the "HI" setting. The "HI" setting doesn't use any of the resistors and that's why it works. These resistors are near the blower and the blower is beneath the dashboard on the ...

fan switch) It sounds like the blower resistor needs to be replaced. Auto Zone will have the blower resistor that you need to replace and will have the step by step instructions for you to get the job

...fan blower resistor swith keeps burning out on the lower speeds on the switch. I have replaced it 3 times and when I take the bad one out it appears to be burnt out on speed two however it works fine ...

blower fan control problem The blower fan in my 2002 Town and Country is continuously running at high speed. It does not matter what position the speed control switch is in. The only way to turn the ...

fan speed) or bad blower motor. Check for power to the fan speed switch, if it's good move to the resistor switch( this switch is normally located near the blower motor and is bolted to the air box to

...blower motor keep running on high, even when key is off? battery was dead, 10 below, charged battery got stated drove to warm up, fan was working fine, then started running on high and won't shut off ...