...clock position and it lines up with a mark on the block. Do not turn the crank or the cam independent of one another, as the valves can be bent. Remove the spark plugs to ease turning the engine when ...
...remove the timing belt, is there any marks before removing?. Yes, good thinking. the bottom pulley will be marked AT "O" and the cams will have a mark at 12 o clock. if they are AT 6 o clock, then ...
remove plastic cover and crank pulley line marks on cam with marks on valve cover should be at 12 o clock then there is a notch in crank gear that lines up with *** on the block at about 1 o clock the
...clock position. on the camshaft there may be 2 marks 180 degrees apart from each other. number 1 cylinder is on the passenger side front, remove the distributor cap and align the ignition rotor to ...
...remove a clock spring assembly is to remove the steering wheel. Of course, if your vehicle has an airbag system (SRS) you'll need to unscrew it from the back and disconnect that first. If you don't ...
Question about Isuzu Cars & Trucks
...mark on the front top cambelt gear is at 12 O clock and with starter motor removed you will see 3 lines stamped in the interuptor ring that is bolted to the rear of the flywheel if manual on early ...
Question about Mitsubishi Lancer
The clock stays on in my 1996 buick century v6 and the radio fuse in glove box does not effect it, i tried removing it and had clock still on , is there a secondary fuse for clock? Look for a "3" Amp ...
Question about Mitsubishi Lancer
...clock position. The marks should be lined up. If not, repeat the process to find top dead center (Step 5).7. Loosen the tensioner bolt and push the tensioner away from the belt. Tighten the bolt ...
... undo steering wheel bolt & mark position of steering wheel to colum splines. 8) remove steering wheel with suitable puller (NOT a hammer) 9) unclip clock spring & replace 10) reverse ...
...mark at 6 o'clock. Make sure when you put the cam gear on the cam that the location pin fits into the gear to position it correctly. Jeep recommends that after putting the chain and gears on, you ...
948 questions posted
Usually answered in minutes!
997 Questions
213 Questions
209 Questions
136 Questions
57 Questions