2003 Mitsubishi Lancer "front" Questions

Ad

Question about Mitsubishi Lancer

1 Answer

How do I replace a front wheel bearing? front wheel bearing is pressed into hub and has retaining clip on rear and then cv axle shaft comes through center and has a nut and keeper pin. Rule of thumb ...

Ad

need to find front end alignment specs for 2008 mitsubishi lancer GTA Unless your a front in alignment pro, take your car to a specialist, spend the $50.00 or so and have the front end aligned ...

Ad

...Trigger: Yellow Car Stereo Amp Trigger Wire: N/A Car Stereo Amplifier Location: N/A Car Audio Front Speakers Size: N/A Car Audio Front Speakers Location: N/A Left Front Speaker Positive Wire

Question about Mitsubishi Lancer

1 Answer

Miss fire in #2 Cylinder where is cylinder 2 located? Front of the engine is where the belts are located, #1 is the front cylinder closest to the belts. Followed by 2, 3, and 4. So the #2 cylinder is ...

i need a new front ecu do you know of any other i need a new front ecu for my 2002 lancer oz rally do you know of any other cars that have the same front ecu i think if u open it u p the chip is ...

Question about Mitsubishi Lancer

3 Answers

replacing front wheel bearing Just wanting to know how difficult it is and if any special tools are required to change the front wheel berings on my 2003 mitsubishi lancer those are sealed units and ...

Question about Mitsubishi Lancer

1 Answer

front end clunk When turning and going over bumps at low speed about 30 or less there is a pop or clunk fro the front drivers side. It feels like it happens as the weight transfers on or off the ...

...es. help? Not 100% sure on that particular model but usually you either have a couple of bolts at front of seat down close to floor to remove, one on each side, and if no bolts, you grab front of ...

When put in reverse - is a very bad noise in right front wheel. 1998 Mitsubishi Lancer. When the car is put in reverse there is a clicking noise in the right front wheel. Can some one please help. ...

vibrating rattle in front of the car that stops vibrating rattle in front end of the car that stops with braking and acceleration. Sounds like two little drums being hit. Wheel nuts are loose. Tighten

Not finding what you are looking for?
2003 Mitsubishi Lancer Logo

948 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...