...three things in the misfiring cylinder: spark, gas, and compression. One of them is wrong or missing. For spark check the spark plug and wire. Make sure you have spark on the plug wire, a strong blue ...
three things: loss of spark; the air/fuel mixture is too far out of balance to ignite; or loss of compression. Loss of spark includes anything that prevents coil voltage from jumping the electrode gap
Three long flashes followed by 5 short flashes would be code 35. If there is more than one fault, the computer will output the codes in succession from the lowest numbered code to the highest numbered
...three things to happen inside the engine, compression, fuel and ignition, without any one of these components the engine will not run. Compression - Engine compression caused by crankshaft rotation ...
Question about Mazda Tribute
...three wires provide a ground circuit, a power source, and a signal output to the PCM. The power source is vehicle system voltage and the ground circuit connects to chassis ground. The signal circuit ...
...three things to happen inside the engine, compression, fuel and ignition, without any one of these components the engine will not run. Compression - Engine compression caused by crankshaft rotation ...
three things to happen inside the engine, compression, fuel and ignition, without any one of these components the engine will not run. Follow the repair guide below: Engine Configuration with Camshaft
...three weeks ago with overheating issues. It would overheat under very cold temps (outside temps in low teens and under). It turns out that I'm an idiot and was looking at the wrong fluid reservoir ...
...mixture ratio - 02 sensor at backstop) it would blink twice, pause, three times, pause, twice, pause and stop. Always read the codes with the engine off and key in the ON position. Good luck - take ...
283 questions posted
Usually answered in minutes!
609 Questions
615 Questions
319 Questions
327 Questions
287 Questions