2002 GMC Sonoma Extended Cab "5 oil pump removal" Questions

5 / 16 (5mm) thick bead of RTV sealer to the oil pan at the front crankcase cover sealing surface. Then apply a 1 / 4 in. (6mm) by 1 / 8 in. (3mm) thick bead of RTV to the crankcase front cover at the

...5. Fuel filter 6. Bank 1 & 2 O2 sensors 7. Battery 8. Fuel pressure regulator 9. Fuel pump was tested and is holding pressure 10. Rotor button 11. Distributor cap Smell of the oil,to see if the ...

...oil pressure WILL cut fuel delivery to a chevy 2.2 engine. If this is the case it will not start at all. 4. When it cuts out and dies, pull off the road somewhere and reach under the truck, ...

...oil pump and loosely install the two oil pump bolts.3. Install the oil pump screen and cover and install the three oil pump screen and cover bolts.4. Install the timing chains.5. Install the oil

...mating surface on No.5 main bearing cap. Finger tighten pump attaching bolts. Tighten attaching bolts to 41 Nm (30 ft. lbs.) torque. Install the oil panThis procedure is for the 3.9L, 5.2L and ...

5 unplug oil level sensor if equipped 6 bump oil pan with a RUBBER mallet to break the gasket seal 7 remove oil pan, you might have to raise the engine with a jack placed under the front pulley, use a

oil pump. 5. Position the oil pump on the crankshaft and install two (2) mounting bolts. 6. Position the primary timing chain tensioner and install the two (2) remaining bolts. 7. Tighten the pump and

...5), and remove oil pump assembly. Mark mounting bolts for proper installation during reassembly. To install: Clean the oil pump and engine block gasket surfaces thoroughly. Position a new gasket on ...

...oil pump located where is the oil pump located at on a 2002 bmw 530i series Its inside the engine and youwill need to remove the sump to get at it and to do this you will have to take the engine out ...

...Oil Pump ... ? 5:08 https://www.youtube.com/watch?v=BgvGjfzrRjU May 10, 2014 - Uploaded by dezertol Ford F150 5.4L Timing Chains and Guides, Oil Pan, Oil Pump, Cam ... i am looking into changing the ...