2000 GMC Sierra "remove ac heat control" Questions

AC as well. To replace these parts (blend door and blend door actuator) you must remove the entire dash from the car. Always have this problem confirmed by a dealer or qualified repair shop as it is a

...AC. Is there a vacuum leak? How do find it Try this, as there is a old TSB for this issue. Remove climate control head from dash, carefully dissasemble and clean electrical contacts with a little ...

ac under the hood, nothing changed. nothigng works and its cold out. any clues to check???? start with the obvious... you have a short circuit... i presume the fuse you have to keep replacing controls

...AC Hello jol..... these Sierra's generally have dual controls on the dashboard. Check to be sure that the passenger side is set to a low temperature, say 60 and then see if you get cool air on ...

...AC works fine. Air blows fine just cold when set all the way to hot. I drive it 20 to 30 miles and still no hot air. The temp gauge reads just below the middle.. ANy help you can give? I experienced ...

...AC during travel as well. i recommend inspecting the cooling fans while the engine is running. they should cycle during the running period. if this is not the case, you will need to test the ...

...on panel, full fan full heat,controls don't change climate control requires the ac to work as well to vary the heat temperature and remove humidity from the cabin air. Check that the ac is working

...ac/heater control unit? 1. Remove the dash around radio (just clips) 2. Remove 2 screws pointing up . (You do not need to remove screws which are parallel to the floor) 3. Remove screw pointing up on ...

...ac or automatic temp control. Sounds like the temperature motor is failing ( automatic Temp Control) You can get to this through the glove compartment, though it is hard. The motor sits on top the ...

...AC will come out. When you move the selection levers, there's a few things that happen. Vacuum is applied to the doors (which are inside) and they open or they work using cables to move the doors or ...