...replace crankshaft sensor on grand prix gtp The above link is for a video how to replace the crankshaft sensor on a different vehicle than your ,but the procedure is the same for your vehicle. The ...
Question about Buick Park Avenue
crankshaft sensor now car wont start just turns over Ok had a problem with car stalling and cranking after cooling off engine light was on jump terminals with paper clip got code 17 my car was running
...going out,cus the oil switch is connected with the fuel pump fuse.my wife car was doing all of this to her, I even replace the main computer cus it also went out after i put new crankshaft
...crankshaft position sensor replaced, battery cable ends replaced, wires from ignition module to crank/cam sensors repaired. Check the number on the ECM . If it has the number 1228253 on it that is ...
Question about Buick Park Avenue
...replace car still starts buafter i drive it it cuts off but starts back after 20 min. Ignition control module could be the problem , but without doing some test's that would just be a guess . Videos ...
...1994 buick ave shuts off abruptly while driving, even on highway, every 150 miles or so. replace the crankshaft poistion sensor CRANK SAHFT CENSOR OR BELIEVE IT OR NOT MINE WAS THE HARMONIC ...
...the crank shaft sinsor located? where is the crank shaft sinsor located in the engine? just beside the lower crankshaft pulley. The crank pulley aka. balancer will have to come off to replace
...the crankshaft sensor did you line it up with the harmonic balance reluctor?On the cam shaft sensor,did you notice if you put the reluctor back on the cam gear when you installed the timing
Crankshaft Position Sensor or the sensor itself. Find the wiring harness to the sensor and wiggle andpull on the harness with the engine running to see if you can make it die. If it dies, you probably
624 questions posted
Usually answered in minutes!
690 Questions
585 Questions
537 Questions
482 Questions
474 Questions