2007 Mitsubishi Eclipse Spyder GT Convertible "top motor" Questions

car. Hope this helps you the electric motors on the top have shear pins located on the drive gear of the motor. It could be you sheared the pin. I have had the same problem and that was the fix for it

...motor for the top checked with a volt meter to see how much power is going to it. if theres a problem with the wiring and its not getting enough power to it, it wouldnt work properly. if it does have ...

...top relay?? behind the rear seats, their is a relay or motor for the convertible top. with out it, it doesnt work. is it called a motor or a relay? It is 2 of the same thing. Motor + Relay. ...

...top only opens haf way You are probably low on fluid. The pump/motor/reservoir combination is probably behind the rear seat. Fill it with ATF with the top down. Cycle the top as much as possible, ...

...motor/reservoir combination is probably behind the rear seat. Fill it with ATF with the top down. Cycle the top as much as possible, repeat till the reservoir accepts no more fluid in the down ...

...the top doesn't work it makes a sound. When i press my button for the top to close or open it makes a sound and obviously doesn't open or close im not sure what the problem is weak motor. replace

...top motor wires in one direction only. There is a switch located just above the left rear brake light, peal bake the trunk liner and you will see it. It says manual/auto, switch it back to auto and ...

my top wont go down i already checked to switch that is not it. i can here clicking and motors just not moving. The mechanics are hidden in the trunk ,must reveal.Bad pump relay will keep the top ...

...top down? first unlock latches locate up on roof under the sunvisors. then roof switch located on center consoul just before the shifter. back to you to open, and forward to close. if that dont work ...

motor) of the carb there is a spring loaded insert that came out of mine. luckily it was sitting on top of the motor so I just put it back in and got a new screw and have had no problems with it since