2008 Dodge Caliber "remove back panel center console" Questions

...back on parking brake (5) to the upright position. 2. Open console door and remove two screws (1) fastening console to rear floor bracket (3). 3. Carefully pry up until the retainers (1) disengage ...

...of console? Center consoles usually have screws on each side and on back panel holding it in place. Remove the screws and you can lift it up over the transmission lever on floor to gain

...back on, it was no where to be found. I believe it slipped behind the small crack between the change holder in the center console. I have lost many debit/credit cards due to this crack. Does anyone ...

...back out of the instrument panel and remove the console from the vehicle. Fig. Fig. 2: Exploded view of a typical console mounting To install: Position the console in the vehicle by placing the front ...

back to me if you have any questions. REMOVAL & INSTALLATION, Climate Control PanelRemove the center console trim fascia. Remove the radio to allow access to reach behind the control panel. Remove

...REMOVE TWO 8MM SCREWS FROM SIDES OF CENTER CONSOLE FROM BACK SEAT. PRY CUP PANEL SECTION THAT WAS HELD DOWN BY SILVER SCREW ...PRY UP TOP HALF OF CONSOLE STARTING FROM SECTION WHERE ARMREST DOOR IS.. ...

Remove the center console trim panel, starting at the ash tray end. Open the ash tray, pull each corner out. They are tight the 1st time. Total of 6 or 8 spring clips hold this on, work you way up the

...remove the glove box, it is held on by a couple of screws. Open the passenger door and begin removing screws. This exposes a screw holding the center console panel on. The procedure for the driver ...

...back and remove the trim ring around the shifter. Remove the storage bin and upper finish panel, now remove the remaining bolts and remove the console. it is bolted to the body floor pan, dead center ...