...no avail.I have to turn it on with manual cool button behind the front panel.I does not turn on or off with the remote Regards Daniel Clifford Indoor room sensor and coil sensor defective. Replace
...to unit. Again plug power on unit and start with remote and try to cancel the timer on and off. Press set. And also cool setting must be minimum 3 degree less than room temperature. Helpful
...cool mode. If while settings there any beep sound? If not transmission problem between remote and PCB. Replace batteries and check once again. If beep sound comes and no start, check compressor is ...
...cool air into house. Switched off and went to turn on again 2 weeks later, no response. Screen of controller blank, will not turn on? Where do I start to look? Hi, if the unit has a remote ...
...remote. If the unit will not start "manually" - I would look for a "reset button/switch" (*not all units have one) and reset it. Note: if after resetting the unit - it still does not run then proceed ...
...cool and temp all the way down at 60 and just blowing warm air. Wondering where i might start. Can't tell if compressor is running or not. doesn't sound like it is kicking in. if unit is more than 5 ...
Question about Kenmore Heating & Cooling
...COOL mode, fan blows ambient air for couple of minutes, then COMP solid red light (not flashing), turns on exhaust fan (but not hot; same as ambient air blowing out the front). Also exhaust fan will ...
start, check to see if the fuse or protector trip is blown. Also inspect the batteries in the remote controller and the electrical plug on the unit for proper connection. If the unit is not cooling or
...start when the overload resets, the overload will again cut the electricity to the compressor. This cycle will continue indefinitely. (Always allow three to five minutes before restarting the ...
28 questions posted
Usually answered in minutes!
90 Questions
61 Questions
42 Questions
37 Questions
47 Questions