Kinderkraft Vermont Crib "bolts toddler bed" Questions

...toddler) rail loosen the two front gold bolts left and right side of the crib and remove the dropside, once you have removed the dropside replace with the streight rail. Always be very careful and ...

...toddler bed rails to the crib frame. Use two 38mm Allen bolts on each rail. There are pre-drilled holes in both the rail and the crib frame. Line up the holes and then loosely screw the bolts into ...

...toddler bed. It is a Chidesigns i think it was a carollton bed. please tell me how to do it. thanks 1-Lower drop side to lower position. Then on the opposite side of the crib, remove stationary side. ...

...bolts. Anyone else have this problem??????? I know the floor model at the store is the same design as mine!!!! Nevermind........... I think I found the soloution they included the wrong instructions ...

...toddler bed. I am needing instructions on how to convert my Bassett New HAven 3-in-1 Crib to a toddler bed. Please help! This site has instructions for the cribs listed below. The 1st two listed seem ...

...toddler Part needed: Allen Wrench Safety rail Safety rail bolt Make sure the mattress support in in lowest position. Remove the front top rail and front panel. Attach both safety rails ( small side ...

...toddler bed? - i'm assuming that i somehow have to remove the sliding gate Use the allen wrench that came with the crib to slightly loosen the two bolts on the moveable gate side (bottom) then shimmy ...

...toddler bed I read to take off the sliding side rail, but do I leave the other side rail in place. Or do I also remove that side? Typically you can loosen the bolts on the side of a crib slowly until ...

...toddler beds that I need parts for.How can I find them? Generation 2 went out of business. Most hardware stores will have the bolts you need for these beds. The barrel nuts are available at Lowes

...toddler bed...Help! The model number is DV623B4 step 1: detach the front panel (part j) from the front posts h(1) and h(2) using allen wrench Step 2 if mattress support (part K) is not in the lowest ...