...water from coming back into the tub. The drain line check valve must close in the back flow direction or the piston valve in the collection chamber may not reopen into the tub after the pump out is ...
...tub are cleaned out, then check all the wash arms for any contamination, particles, junk anything that could restrict the flow of water through them, it sounds like the wash arms are not rotating ...
...water after washing a load of dishes. We diagnosed the problem as a bad pump and I replaced it. We've had very poor cleaning since changing the pump. I thought maybe my wife wasn't using hot enough ...
...water from flowing into the machine. The water must be shut off at the wall. As with the previous failure mode, the variant of this failure mode is that it may take the valve a while to completely ...
...water is having a hard time flowing into the pump to be circulated. this youtube video will show ya how to take apart the pump to get to and clean filter. http://www.youtube.com/watch?v=iRCCrEwrst8 ...
Question about Maytag Dishwashers
water in the tub. I have read about the water needing to heat up for the cycle to advance. When I check the water that is left in the tub it is warm but not hot. The heating element is not hot either.
...water in the bottom of the tub and make sure there is enough water in there. there should be about an inch of water in the bottom. If you think the water is low then add some by using a pot but not ...
...water in the tub for washing. The tub has to have the right amount of water in it to pump it up to the top. It is also possible that the pump has debris in it that is restricting the flow. Clean out ...
...water enters tub it floats up to cut off water when its full. Also check that valve where water lines connects,check wiring on it using a voltage meter for 120 volts ac when the d/w is supposed to be ...
14 questions posted
Usually answered in minutes!
438 Questions
252 Questions
192 Questions
187 Questions
117 Questions
