...washing machine brushes? top load washing machine. I opened the motor but I could not locate the brushes. Some motors do not have carbon Brushes as its a induction motor as a opposed to a reaction ...
...washing machine motor I'm trying to turn into a pottery wheel. (!) the model number is 110.44836301. Believe it's from a Kenmore Elite H3 front load washer. Anyway - trying to figure out how to wire ...
...machine and look for loose (broken) wiring in the field winding or the wiring to both brushes. If this is an induction motor, there will be no brushes, just a number of wires that allow the motor to ...
...motor is likely to be an induction type multi-speed motor - I have seen only a few of these and they are able to run at different speeds by having multiple windings and lots of connecting wires and ...
...induction motor, you didn't quote a model number for me to be sure, if carbons are ok then check the main pcb (module) to see if any thing is burnt or damaged, well thats a start to be going on with, ...
motor has an Rotation Position Sensor it will be on a rotating mass such as a flywheel or a pulley. The sensor needs a magnet to send the sensor a line of flux across the induction coil in the sensor.
Question about Maytag Washing Machines
...induction motor and those seldom go bad and the windings on the motor also tested good. Should I try to replace the CCU with the correct part? What else could I try, My CCU has no evidence of ...
Question about Hotpoint Washing Machines
...machine tipping as described above, and possibly the pipe removing from the pump to check it. 3. A Faulty Pump:If you have done everything described so far, then you have checked for obstructions in ...
42 questions posted
Usually answered in minutes!
2,660 Questions
1,146 Questions
974 Questions
650 Questions
256 Questions