...transfer belt had blue smudges in the same pattern as printed on the paper. I cleaned the belt with a soft rag and reprinted - the same thing happened: still get blue smudges. Any suggestions? Thanks ...
Question about HP LaserJet Office Equipment & Supplies
...transfer belt(ITB). 2) Causes the toner to move from the surface of the ITB to the paper. In the CLJ 4700, there is an Electrostatic Transfer Belt instead of an Intermediate Transfer Belt. This ...
Question about HP LaserJet Office Equipment & Supplies
...colour TONER CARTRIDGE. A problem with the DRUM UNIT (only a single drum in this printer) or the TRASNSFER DRUM , or BELT (this printer has both a transfer drum and a belt), would affect ALL
just replaced the imaging drum so that should not be the problem. Most Printers that are laser have a transfer roller or transfer belt. If you have replaced all the drums this can often be the problem
...transfer belt. Known issue with this machine. Hope this helps Blank or white pages Your software application is sending an extra page-eject command. ? Check the software?s printing configuration ...
Transfer Belt (ITB, Transfer Kit) HP Color LaserJet CP4525 CM4530 1. Open the printer's right side door. 2. Use the blue lever (see callout 1 in picture below) to lower the secondary transfer assembly
...transfer belt, pull the belt out and look closely at the end that goes into the printer first. If there is a bunch of loose toner there then the waste toner system is backed or clogged. If printer is ...
Question about HP LaserJet Office Equipment & Supplies
...transfer belt unit. This is caused by an area of the belt that is not being cleaned very well. This probably tends to show up when you are running mutilple prints of a page. So it looks like to may ...
Question about HP LaserJet Office Equipment & Supplies
transfer belt with an air compressor but it didn't work. I have 59% life left on my transfer belt so this is not the solution. Is there anything else i can do to get my printer to work properly? Hi, I
...transfer belt, it can only get there by either being put there intentionally, or leaking. Failure of Transfer Belt is normally degraded print quality - usually poor density, or a failure of the ...
26 questions posted
Usually answered in minutes!
1,429 Questions
1,001 Questions
724 Questions
663 Questions
593 Questions