Frigidaire FRS23H7CS Side by Side Refrigerator "three pins compressor" Questions

...three contact pins, one pairs resistance will be higher than the other. Then check from each pin to the a clean metal part of the housing, there should be not circuit on any pin, if there is its ...

...three pins on the compressor and the device has three holes in it,you line up the holes and push the device onto the pins and to remove it pull back on the device to slide it off the pins,the easiest ...

three compressor pins.when you get it off of the compressor shake it,if you hear pieces rattling around in it it's cooked,that's the easiest way to check it.you didn't send the whole model

...three pins 2 at a time with an ohm meter. You should get readings all the way around. Then test 1 pin at a time touching the other probe to the copper on the outside the compressor. Tell me what you ...

...compressor, but three wires on the relay. This compressor is on a Kenmore refrigerator, model 795-71022-011. The PCB is giving me an LED code for Piston Lock. I would like to test the compressor ...

...three pins on the compressor what goes where The start component assembly goes to the three pins. You have to have this assembly. Always shipped with a new compressor. The 2 wires go the start kit, ...

...three pins of the compressor and there's a certain place that they go they got one on each pen must be the correct pin now you're talking about two extra wires those are what connects with the power ...

...three pins on the side of the compressor is burnt off. Is it worth repairing? Would the compressor be covered under any kind of warranty or recall? It is over 10 yrs old Probably not. Sounds like ...

...three pins. Measure resistance across two of the three pins: C to S, C to R, and S to R. The numbers should be close to the formula: (C to S)+(C to R)=(S to R). If that checks out, then you should ...