Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum "cleaners recovery tank" Questions

...recovery tank rises to top when recovery tank is about 20% full.Thus we are only able to use the steam cleaner for about 2 minutes before having to empty the recovery tank. Ideas to resolve ? Your ...

...recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank. In addition, make sure the recovery tank lid is properly aligned to the tank to seal. Lastly, make ...

...recovery tank is not collecting dirty water. my recovery tank is not collecting dirty water need answer on how to fix it? Thanks remove tank reajust and push down and clamp hoover carpet cleaner does ...

...recovery tank is not installed correctly allowing air (suction) to leak. On most models you can remove the solution recovery tank, turn the unit on and feel for suction where the tank fits onto the ...

Hoover Steam Cleaner - dirty water is not coming up in the tank! My Hoover Steam Carpet cleaner problem: It's not picking up the dirty water. recovery tank (dirty water tank) not on correctly

...recovery tank lid on hoover carpet cleaner The recovery tank lid won't latch to the tank. I made sure the seal was clean of dirt/debris, and it won't quite latch. I've used the cleaner about 5 times. ...

...recovery tank. i must have done something wrong. how do i use this thing? The recovery tank lid isn't locked down all of the way around. The foam filter on the inside of the tank lid is up too far, ...

...recovery tank. Remove the front panel of the recovery tank by sliding it straight up. Slide the convertor half way down into the same slot. (Curved side down). The opening should be facing upward. ...

...recovery tank is full. Located on the lower front panel of the unit, the recovery tank can be easily emptied and replaced into position. To remove from unit, press down on the release button and pull ...

...recovery tank lid, make sure there is at least a 1/4 in. gap between the lid and the top of the filter. Make sure that the lid is locked down in the back, try to push it up, if it is locked it won't ...