...sensor clip is replaced, the logic that tells the printer to feed the paper just to the beginning of the input roller is corrupted. The feeder roller (grey one at the paper feed) rolls to feed the ...
...for each make and model thanks Error 200 for Lexmark printers: "Input Paper Sensor was not triggered - Paper may be jammed at the sensor. Remove toner cartridge for better access to jammed
sensor which locate around the paper input roller area.you need to check 1) the cassette push in the well position which can touch the sensor well egnough 2) find out this sensor and adjust the sensor
...9000s system error The Paper-Axis or the Scan-Axis Motor moves the Carriage, but the input from the Linear Encoder Sensor does not change. You are going to need a tech to check out the
Question about Lexmark X Office Equipment & Supplies
...sensor needs to be replaced and the new one will need to be calibrated in the same manner." Let's say the readings are good and you set the Input to 0.0 for auto calulate and still have a paper end ...
...input voltage is below 0.5 V. Finisher* paper conveying motor problem ? The paper conveying motor lockup signal is detected for 0.5 s or longer. Finisher* paper conveying belt problem ? An on-to-off ...
Question about Minolta Office Equipment & Supplies
Input/Output Check[8-5 Registration Sensor]. Manually activate the actuator of the Registration Sensor (PL 2.4). The display changes. Y N Check the connection of P/J104. P/J104 is connected correctly.
error 50.7 colour laserjet 6030 i have changed all the circuit boards including the dc controller board.i also tested the motors they are fine.the fuser drive gear was broken i replaced it Its either ...
...sensor and note volts reading. use following formula High reading + Low reading / 0.5 = Value to use e.g 2.8 + 1.4 / 0.5 = 2.1. use result to change value of input using line key once set press feed ...
Question about Konica Minolta Office Equipment & Supplies
...input. You did replace both at the same time. Cleared the counter for the transfer roller in the service mode?. Anyway the code P-5 and P-21 have to do with the registration sensor located below the ...
418 questions posted
Usually answered in minutes!
1,487 Questions
1,353 Questions
1,277 Questions
961 Questions
741 Questions