Honeywell ER150B Air Conditioner "emergency heat strips working" Questions

emergency heat relay that is not on my unit. How should the unit be wired without the heat realy as i know this is my issue. I also use an outdoor thermostat between the compressor and thermostat that

...emergency heat settings. This scares alot of people but if your heat pump isn't working and you have to switch it to emergency heat until you can get it fixed,. That means that the system is only ...

...heat" to "emergency heat" and see what it will do. When the HP is not able to keep up with the demand for heat then the heat strips come on, but they typically come on only when the room temp has ...

...emergency heat and it also should have a wire connected to it so that terminal can supply power to the strips when the stat is switched into emerg heat . you can identify the terminal from the wiring ...

emergency heat and turn the thermostat up. If you get heat accompanied by the traditional strip heat burnt smell, then you know the electric heat strips are working. The second thing would be that the

...as a emegency heat it works as long as the fan is set to on If you are using strip heat as seperate mode you must install a fan isolation relay which would be energized by emergency ht mode of

...emergency heat and get hot air. also there is a cycle when the heat pump blows ice cold air for about 2 minutes while in the heat mode. Hope yoy have some advice. Thanks FIRST YOUR OUTSIDE UNIT ...

...Emergency Heat when it gets under 32F outside- does not understand and is wasting your money)1) Normal Heating  - temp drops to much below set point at thermostat (usually around 2-3 degrees, ...

...emergency heat manually to keep the rooms warm. Once the weather warms up and the ice/frost melts, I reset the power to the system and it works fine. The unit seemed to work ok this past summer with ...

...emergency/auxillary heat on to see if the heat strips kick on? If that works, then it sounds like your unit is low on refrigerant. If your not sure about the ER/Auxillary, there should be a switch on ...