...head unit indicates that it is grounded. Is this normal for this wire when the head unit is OFF? However, its still shows ground when head unit is on. Possible bad head unit? Everything else with the ...
...cde-7872 head unit the speaker leads on this head unit have no sound,,, they are blown, either have them fixed or buy another head unit or the best way is to just use the RCA outputs from the head ...
...head unit powers off at high output it could be several things. 1. check ALL your grounds (head unit, amp, etc..) 2. it could be a a short. 3. head unit could be defective disconnect the amp ...
...head unit and so when you turn off the radio you would nolonger need an antenna so it powers down and would lower the antenna.Depending on the head unit you should have one output for the power ...
head unit volume is all the way down like if both rca's were making contact i bought a different pair of rca's but same results, this happens without my eq connected,but when i connect and turn the eq
Question about Blaupunkt Car Audio & Video
...not a head unit. The point of that is to power the speakers. The output on the head unit plugs into this, and the speakers plug into this. You tune the station on the head unit in the ...
Question about Alpine Car Audio & Video
...head unit via the AI Net cable, then connected the power and speaker leads to the amp. The amp powers up, but no sound will come out. Tried to see if something had to be turned on / set on the head ...
...head unit must have remote-on capability. If there is no hole in the head unit than you must use some other form of power on. If the Amp supports it, use the audio on setting (look in the manual for ...
...head unit and everything turned off the head unit came back on but i havnt been able to get sound from my amp since it sound like u got a short , check ur wires make shore ur head unit is working to ...
Question about AudioBahn Car Audio & Video
head unit to the correct terminal on the amp, so the amp will only power up when the head unit is on. 4 Remember to run the signal (speaker) wires in a chase separated from the amps power wires, so as
24 questions posted
Usually answered in minutes!
57 Questions
25 Questions
19 Questions
28 Questions