Pyle PLMRA420 Car Audio Amplifier "key 1 wires" Questions

1 ohm most car-audio subs are rated at 4 ohms, as opposed to home audio's 6-8 ohms. If you have a pair of 4 ohm subs, wire all 4 positive terminals to the positive terminal on the amp and the sam with

...twisting both power wire together. this will cause your cd player to come on at any time with out a key, so in your case almost sounds like your remote wire is hooked up to a constent power source ...

...1 foot long and it goes on the ground or negative 12 volt connection then a bolt on the car you may need to sand off the paint for it to work, 2 a RMT or remote wire that is normally in the middle of ...

theres a loud huming noise if my deck is not playing music and the keys are in the ignition You probably either have a ground wire loose or a short in your wiring. If you're familiar with the wiring ...

...1.verify connections...Make sure your ground wire is grounded to a location on the body where you will sand the paint away to make good metal to metal contact. 2.with a volt meter check for battery ...

...Key 12v to hold memory settings 2 Speaker Unit will have 4 wires - 2 to each speaker one wire of each pair will have a stripe (say negative) keep striped wire to same speaker terminals to keep the ...

1) sharing a common with another small awg yellow. Applying power to the main red/black power wires does not turn on the LED. Do I need to apply power to a wire other than the main red? which of the 4

...key. No matter the source, you need to fuse the wire with a 1 amp fuse at the point where you connect to the power source. Hi my name is Branden I have a sentrek 2 channel mosfet bridgeable amp and i ...

...key is not in the ignition. What can I do? It sounds like you have constant 12volts applied to your remote turn on lead. The amplifier will have 3 connections for power: 1. 12volt constant 2. chassis ...

...1 for subs, other for speakers. The one for speakers just started shutting off If I turn the volume up past half it shuts down and when I turn key off it resets and works till volume is raised again ...