Intel D102GGC2 Motherboard "bios reset jumper" Questions

...reset your bios jumper. All boards have the jumper, you will move the jumper from it's current position to the next pin. Example. It has two pins. Jumper Pin 1 and 2. The jumper might current be set ...

reset the bios." Please explain "bios jumper" - is it the bios battery? and How do I reset the bios? http://www.intel.com/products/motherboard/DG31PR/index.htm.....is discontinued...any

...reset the BIOS/CMOS you need remove the jumper and put it into reset mode. Once you have a look in the motherboard manual you will get to know. There will be three modes in bios jumper, there will be ...

...reset the bios.open the system unit, locate a small battery, near the battery, there should be a small jumper. pull the jumper upwards, you will get a small square plastic cover. now turn on the pc, ...

...reset bios! without jumper can turn on but if i put the jumper again dont start when i try to put on!. Hi, Putting the jumper on the two pins shorts out bios and resets it. Computer will not start if ...

Reset bios on motherboard Try following the instructions on this WikiHow: http://www.wikihow.com/Reset-Your-BIOS BIOS access can be gained by hitting either a function key or the delete key. In the ...

...reset the BIOS You can reset bios with 2 methods. (1) Pull CMOS cell from motherbord for 10 minutes. Then power up the computer 2 times. Then all settings are defaults. Then reseat the cell. (2)You ...

reset you bios and see. i will tell you simple way to reset your bios There are 2 ways you can reset your bios. 1. On the motherboard there is a small watch battery. Remove this battery along with the

...reset in my bios Turn the computer off. Take a close view of the motherboard. Look for 3 gold pins in a row, with a jumper connecting #1 to #2. Move the jumper to connect #2 to #3. Count to ten. Move ...

...reset the bios settings. (To do this, refer to your motherboard manual.) 4. Once already done. Close the casing and power up your computer. See how it works.:-) Here's a direct link to the user's ...