Weber Genesis Silver B Grill "grille second third burners" Questions

burners run well, blue flame no yellow. I changed the regulator with one from home depot but the same problem exists. Does the regulator need to be sized for the grill? I did not buy a weber regulator

...second or third burner the gas cuts off. is this a problem with the regulator or the grill itself? try this turn tank off make sure all knobs are in the off position disconnect tank reconnect tank ...

second burner and the flame goes down slightly, I light the third burner and it goes out completely clean all the burners and the orffices , check the gas is full if lpg ,check gas line is not blocked

...third, all burners would go to minimum. Now I can only use one burner above minimum. Upon turning on the second burner both go to minimum and will not build temperature. I have replaced the tank, no ...

...system time to build up to the proper operating gas pressure.  After starting the first burner, open the second burner to high.  After that lights up, do the same for the third

second burner, the flame was immediately extinguished. I tried the same thing with the third burner and I had the same results. I changed the tank even though the very simple weight gauge on the grill

...second and third burner are not lighting. Close the propane tank valve and disconnect the hose/regulator from the tank. Reconnect the propane tank and very slowly open the tank valve. You may have ...

...second and third take up to 3 minutes IF they fire at all. burners are not clogged. If the first burner's flame characteristic's look right, the remaining burners need to be removed and the venturi ...

second burner it does not light even though we think we can hear additional gas going to it. We are also unable to light the third and fourth burners. What can we do? Hello, there is a carry over tube

second and third burner burns with a low flame. Burner closest to gas supply works as usual. This problem can be caused by a number of things. Is this a new grill? If not, is this a new problem? First