...be? make sure push start switch is not stuck pushed in.Also sounds like the switch mounted on the motor could be stuck, which means new motor. Does motor start and stop with timer being moved to
...motor starts then stops. Flicking the fan on the motor it runs again for a short time. The motor appears under some strain but nothing is evident. Belt looks in good condition and tensioned well. ...
Question about Whirlpool Dryers
stops moving my blower motor works for about five minutes on my dryer then begins to make a grinding noise and the motor stops moving but is still hot. replace the blower motor to fix the problem
...stops and you try to restart it do you hear a buzzing sound? If you do then you have a overheated drum motor. Full of lint or bad motor bearings. If bad motor bearings only solution is to replace the ...
...overheating. Solution, Check for lint blockage around the motor and for possible overloading. If dryer repeatedly stops during its cycle, especially during consecutive loads, replace motor. Good ...
Question about Kenmore Dryers
...it to start again. Of course, it runs for about 10 minutes and stop again. That is gong to be a bad motor. $72. Tools needed: Putty knife nut-drivers screwdrivers adjustable wrench locking pliers ...
...when your dryer stopped and you tried to restart if no noise the over load thermostat embedded in motor is suppose to open and not allow it to start then the motor cools down now it works till the ...
stops after few minits , heat works,went is ok.only thing not working up to programmed time so cloths are not geting dry. could be thermal overload in motor its a motor protector in the motor when the
Question about Kenmore Dryers
...stops midcycle and will not be restarted for a 20 to 30 minutes. I think it might be motor temperature - how do I test this and is there a remedy other than a new motor? OH OH sounds like a bad motor ...
...from the controller unit to the motor and if the feed voltage stops the fault is with the controller unit. If not the motor and drive must be checked, check the capacitor to the motor
1,106 questions posted
Usually answered in minutes!
1,123 Questions
790 Questions
215 Questions
219 Questions