LG 4775er2002a Door Hinges for Wm2277hb Tromm Front Load Washer "turn sound back washer" Questions

...sound which most likely means that the bearings need to be replaced. What are the steps to open the washer, remove the back and bearings, replace the bearings, and re-assemble the washer. Thanks. ...

...turn back on. Now in the mean time, when it is plugged in, the light is on the whole time. Is there a reset bottom? No code appears on the screen. Please help? It sounds like a problem with the ...

...turn but it cannot. (Thumping Sound??) I drained the water manually from the filter cleanout door and checked the filter but found nothing in it to clean out. No error codes are displayed. If the ...

...take the whole thing apart? My LG WM-2277HW Front Load Washer had the same problem, I took it apart and it turned out to be heavy corrosion on the drum. just sand it back and it will be as good as ...

...turn back on. Please help! I have checked the outlet and tried holding the power and start buttons for 20 seconds. sounds like the belt may have come off or broke there is no belt on an lg front ...

...turn there is a kind of buzzing sound that sounds kind of like 2 metal rings spinning past each other at high speed, coming from the area of the motor or bearings in the back. I can spin the drum ...

washer makes a noise like it has a coin spining in the motor when it is in use. When I opened the back panel and manually turned the motor, it sounded like a spring was out of place and turning as the

turn, it would buzz and jerk. Took back panel off. Tried starting a cycle and I hear a buzzing sound and some jerking when motor attempts to engage. Could it be a defective Hall sensor? Did a OHM test

...turn back on, tried all logical, pluged in, unpluged, checked door, ect. This sounds like something has shorted causing the breaker to trip. You definitely need a qualified LG repairman to check it ...

...turn the water back on. If you don't have good water pressure, turn the water back off and remove the strainer that should be in one end of the hose. Inspect the strainer to see if it is stopped up, ...