Whirlpool LHW0050PQ Front Load Washer "sand filter water drain plug" Questions

...sand, filter clean, but I can't see the actual drain pump to see if something might be Can I get to the drain pump or does the washer need to be torn apart? I cleaned out the drain plug- full of ...

...filter water goes all over the floor. I tried blowing through the drain hose and it seems to be plugged up but not sure there. Any ideas? In all likelihood the rubber drain hose is clogged. I had the ...

...filter I noticed the hose is plugged with sand. How can I clean the hose out. That's a real pain. Even if you remove the hose, it is hard to clean out. You can get at the pump end of the hose by ...

...plugged/kinked unplug washer/disconnect power check electrical connections to pump and make sure pump runs check drain pump filter for strings,sand etc plug in washer If this dont work replace

...sand. In that case, pull the washer about 18 inches or so out into the room and tilt it back so the back rests on the wall and the front legs are in the air first before then removing the filter by ...

...filter. When reinstalling plug make sure all sand and debris are out of the threads and apply light oil before screwing the plug back in. If you don't do this you run the risk of breaking the cap ...

...filter. After the three cycles the water came out clean and not muddy. I also took a spray bottle of hot water and sprayed the "gunk" from around the seal to release it and out of the washer. I ...

...filter area including around the plastic pump impellor is a worn or dirty motor. Small grains of sand can get in between the magnetic rotor and the housing preventing it from starting. If you can ...

access panel will get you into the fluff/filter to clean it out. Make sure to get all the threads clean of sand and debris and use light oil to replace the cap or you will break it trying to reseal it

...filter is plugged with sand and other build up. and then i'm getting a grey gunk in the washing drum, i'm assuming it is b/c the drain pump is blocked and it is coming back in the machine?? want to ...