Whirlpool SB160PEE Gas Single Oven "takes along time" Questions

along time to heat-up. Check for leaks on pipes and fittings. Mix a small amount of washing up liquid and water make sure it is nice and frothy , put around 1 joint at a time (do not light any burners

...TAKES ALONG TIME TO HEAT UP WITH A GAS ODOR. THE GLOW PLUG GETS CHERRY RED BUT THE BURNER WILL NOT LIGHT. WHEN I WATCHED IT IT IGNITED AFTER A FEW MINUTES AND WHEN IT DID THE FLAME ON THE BURNER WAS ...

...along time to get up to heat and your oven doesn't seem to be working you may have only 115 volts of power going to the range rather than the full 240 volts that are needed to power up the bake/broil ...

time the hinges seize up and the WD 40 normally eases this situation). (Don't be confused with the air flow coming out of the oven from the cooling fan as this also runs along the top edge of the door

...time usually around 45 to 75 seconds this would indicate that the thermostat is defective and needs to be replaced. However if the ignitor its taking longer that this this would indicate that the ...

...takes along time to reach that temp. The stove never indicates that the preheat temp. is reached. This just started last nite. Thanks Roxane Hello, welcome to FixYa. If you can provide the complete ...

...along top you will see 2 screws undo but hold door at same time then just lift out and clean. hope this helps I scoured the internet trying to find how to clean inside the glass of my Electolux Icon ...

...along it, it is a plastic ribbon) by squeezing each side of the attachment, the ribbon should lift off. Lift the plastic ribbon up out of the attachment and leave it out for about 33 seconds. After ...

...along time to. the oven is a yr and a half old what could be the problem? Sorry to read about your problem, I hope this helps you out. check to see if you still have 220 volts coming to the oven I ...

...time. If it isn't too old you may try calling thermadore and see if they are willing to at least buy you the parts, as this is a known problem. Good Luck! I recently replaced the display and board ...