...not heat to the setting on the control knob. Would this be in the element or the control part? Replace the surface element switch. is it the limiter switch on the element or the control knob ...
Question about Cooktops
...control switch: The burner control switch regulates the power to the burner. Check if the switch is loose, damaged, or defective. You can test the switch for continuity with a multimeter to determine ...
...control heat on dbl burner The front left burner on my range is a dual burner. When using the dual side of the control, my burner will stay at max heat even though I move the control between low and ...
Question about Jenn-Air Cooktops
...heat setting. My right front dual burner quit working a few days ago also. Are the two problems related, or am I especially unlucky? not related any further then sounds as if you have 2 burner ...
...Heat Control Part No. 320944 has gone bad and needs to be replaced. Looks like a simple procedure, just open everything up, pull the bad Heat Control and replace with new one. I would think the ...
...heat control knobs and can they be replaced? The control knb are being worn need to replace it the terminals are rusty conductance may not flow./not heating the coil. I'm looking for a fan switch ...
...control heat.some model & brand have a different operational procedure,try to read the manual 1st or check the voltage of the unit coz the ceramic have a 4voltage standard for different country. tnx ...
Question about Thermador Cooktops
control panel controls the power to each surface element. If you have no heat at an element and the element and terminal block check ok, then you may have a defective infinite switch. Disconnect power
Question about Jenn-Air Cooktops
knob off and on before the left rear electric element will stop heating. The contacts in the control switch have fused. Replace the switch. You can probably do this yourself. Part should run about $25
Neff T1722SO Ceramic Hob - rings don't heat The controls all work (on/off, ring settings etc) but none of the rings heat at all. Given the controls all work the power supply seems fine. It did not ...
37 questions posted
Usually answered in minutes!
24 Questions
15 Questions