Question about Western Digital Caviar Computers & Internet
jumper setting of that drive and then set the jumper on the second hard drive to a different setting. BOTH drives on the same cable CANNOT have the same drive setting. After installing the second hard
...ATA and it's used as Primary and one is on SATA (WD800JD) and i want to use it as Slave but doesnt appear on My Computer. I have tried with Add Hardware but it tells me that the driver it's not ...
Question about Western Digital Caviar Computers & Internet
...ATA II; 3. Re Jumper settings: the eight-pin jumper block is only used to enable power management on the drive. There are no master/slave settings since there is only one drive per cable; 4. If you ...
...ATA or UDMA, an IDE type interface. Many newer PCs have a SATA interface. You can buy and add a SATA interface card if no additional SATA ports are available on your system. SATA ...
Question about Western Digital Caviar Computers & Internet
...ATA drive and read the Dell info on jumper settings. My interpretation was that both the old drive and the new drive should be set to 'cable select'. This is how I set the disks. Now I am not so sure ...
...Setting a hard drive to function as the secondary ("slave") drive allows you to use the drive solely as a storage unit. You can use the drive to back up valuable data on the primary drive without ...
...jumper setting for model 6v200e0 Need to know maxtor hard drive jumper setting for model 6v200e0 (Serial ATA) here is a poster of Maxtors jumper settings for each kind of drive. Serial ATA drives ...
...jumper setting to slow down your SATA drive's transfer rate, please see Document ID: 193775. - -- (Click to expand) Jumper settings for Seagate SATA drives - -- (Click to ...
...2nd drive...need to change from master to slave on pin settings... hi frined remove your hard disk jumper & u r hard will be slave PLACETHE JUMPER IN THE MASTER AT FIRST POSITION AND REMOVE ALL ...
Question about Western Digital Caviar Computers & Internet
which is the correct jumper settings on Seagate Barracuda ATA IV 80 GB Hard Drive Hello Please see the image below for correct jumper setting Hope this helps, if so do rate the solution
36 questions posted
Usually answered in minutes!
35 Questions
25 Questions