quit working last night. I replaced the fuse and it appeared to work. I reset the clock. I tried it again today, and it immediately shut down. No power. Can anyone help me. sounds like a short in unit
Question about In Microwave Ovens
...quit after a minute or so. The clock also quits every now and then.What is causing this interruption in power? There is a fan inside that blows air across the electromagnet that cooks your food. It ...
Question about Whirlpool Microwave Ovens
I have a Whirlpool old model # RM278BXV-3 and it has started shutting all the way down when heating things up. Contol panel goes blank and quits heating. Open for suggestions. It clears after a minute
...working it shows on the display to press clock key but ... What would cause my Sanyo Microwave to not heat up? Sanyo EM-P672W Microwave Oven Sanyo microwave fuse ... All microwave ovens have door ...
...quit working. no light , no clock, no sign of life. Checked circuit breaker, ok. Any ideas? If your appliance has absolutely no functions at all, remove it from the mains supply, remove the case and ...
...clock nothing total dead. The magnetron tube, which makes the microwaves, is probably to blame. One of the ways they can go bad is to burn out, which causes the smell you noticed. Then they can ...
...quit. After selecting power level and time + Start, the turntable turns a few degrees in each direction, the light comes on, and a few soft sizzles or pops are heard behind the button pad, then the ...
Question about Sharp Microwave Ovens
...working, but the fan don't come on. every thing work but the fan don't come on. lights clock it counts down shut off but the fan don't run and no heat. can you help thanks clyde shelton Quite often ...
power went off for about 2 seconds. when power came on, the clock was still running but touching each and every other button brought no result. cannot change the clock, or use the microwave at all. ...
...quit working. Clock counts down, lights all come on, but no microwaves nor does the plate spin...any ideas? Hi William, The secondary interlock switch is bad. You need an ohm meter to verify that the ...
47 questions posted
Usually answered in minutes!
216 Questions
111 Questions
92 Questions
78 Questions
76 Questions