Whirlpool Cabrio WTW6600SBT Top Load Washer "lid lock wont engage" Questions

...lid wont lock Suds DetectionSd is displayed when the machine/motor control, by analyzing drag on the basket, detects a suds-lock condition, and is steady on while the control then runs a mini-clean ...

lid lock button is flashing and wont unlock I u unplugged the machine and it stopped blinking, the lid unlocked but when I tried starting it again the same thing happened. I cleaned the contacts on ...

...lid lock? Lid circuit is fine but still won't start. I think that the plug itself is the problem from the power surge. Any thoughts on that. The usual reset procedures don't work and the plug sparks ...

...lid lock switch on my amana top load washer lid lock button keeps flashing and wont engage need to bypass so the washer will run I had that problem with a top loader and wedged half of a wooden ...

lid latch is in lock mode: Some Maytag Bravo top-load washers have a lock mode that prevents the lid from being opened during a wash cycle. Make sure that the latch is not in lock mode by checking the

...lock to engage. It won't run with the lid unlocked for safety reasons. The problem could be with the latch motor, wiring, debris in the lock area or an alignment issue between the latch and the ...

...LID LOCK LIGHT STAYS ON NO START: Usually either the lid lock mechanism, the lid lock actuator or the board is the culprit even a disconnected capacitor. MACHINES SAIDS SENSING When the START button ...

...lid lock light was blinking I unplugged it unlocked the door to get clothes out the lid lock light wont come bk on on duet whirlpool but everything else is bk working I even reset it Usually either ...

lid and stick there arm or hand in and have it injured. Most washer are designed so that the washer will only  wash and spin when the washing machine lock is engaged.  Also sometimes it will

...lid switch assembly can fail either mechanically or electrically. Test any electrical switches with an Ohm meter for continuity. The switches should have continuity according to their design. Door ...