Question about Canon Office Equipment & Supplies
...Unit Film. Replace Fuser Film. The White mark of Fuser Film must be place in write side. The White mark reader sensor must be free from dust and Toner. Use fuser oil and white grease for fixing
Question about Canon Office Equipment & Supplies
...fixing fuser film is worn out or broken remove the fixing unit ang check the fuser film if its worn out broken replace a new one . Hope this helps. Please rate my response. Thanks. Have a good ...
Question about Canon Office Equipment & Supplies
...film that press onto the orange rubber roller this together with its plates cables and connectors the unscrew via 4 to 6 screws from the machine is the 'fuser' the 'tekkie' or ...
...problem 007- check fixing film if it is ok then open the unit and take out fuser film apply mixture of some white grease and fuser oil(silicon oil) and put back the film and unit.hope this helps
...fuser film. E000 Fixing problem solution 1. check using tester (V.O.M) the fixing lamp, thermestor and thermal fuse if its worn out or defective change if necessary 2. check the fixing film if is ...
Question about Canon Office Equipment & Supplies
fuser unit consiting of two pars 1-fixing film assy. (Heter unit) 2-fixing unit-(Complete set.) if you have replaced new fixing film assy. in old fixing unit-this may be the result due to the pressure
...fuser flim roll of fixing unit still then the error code display manually and after switch ON the machine also fixing unit is running but getting heat also but after a seconds the same error code ...
...to replace the fuser fixing film and or the upper fuser unit.....the fuser film ripes and the film start to bind up on one side and the sensor can not see the white patch on the film.... Good ...
...sensor. - Replace the fixing film sensor. - Replace the DC controller PCB. Normally you must change the fuser to resolve it. Bye replace fuser film check sensor check sensor board reset *28* press ...
fuser film can not find home postion. Odds are, your fuser fixing film is damaged and will have to be replaced. The cost depends on what model you have? Good Luck fixing film error from fuser unit.get
446 questions posted
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,862 Questions
1,594 Questions
1,302 Questions