...xerox docu color 4lp on the printer display's this message "U6-4 Cycle power" U6-4 sounds like an NVRAM error and could be a bad board. I think they probably be the Main System Controller Board ...
Question about Office Equipment & Supplies
...Xerox 3210 printer, after replacing the Print Cartridge, it is showing "Toner exhausted'. What is the solution? Here's what my Service Manual for the WorkCentre 3210 States: Replace the Print ...
...printer be rebooted. This was an ocassional problem but now it is consistent. It indicates that it is a problem with the scanner or document feeder. What is odd is that if you let the unit sit for 5 ...
Question about Xerox Office Equipment & Supplies
xerox workcenter c2424 error code 39,014.40;33151 getting this error code on start up but if I open and close doc feed cover it resets, any advise Could be a dirty scanner. Not much to check, it is a ...
...Xerox. But you can keep running the printer through the purge cycle and get rid of the ink. You may have to apply pressure to the magenta ink to force it forward onto the heater. To do that just fill ...
Question about Kyocera Office Equipment & Supplies
...printer prints fine for the rest of the day. These printers are only about a month old. Thanks in advance. RD Xerox just gave us authorized service providers notice of this problem. You will need to ...
...Xerox Work Centre C2424 is giving a System Error 39,012.40:10 Hi there I found some thing maybe do for you it may not be rhe right code you have at this moment but it come in handy for you. ...
...Xerox tech had me power down, remove document feeder cable, then reattached cable and be sure it was tight. I powered back up, message stil there, so I opened the little hatch on top by the upper ...
...Xerox machines always refer to toner or drum.Is the toner out , you could give it a shake (might be a good idea to go outside!) Sometimes it will run out without displaying a message(Pyramid of dots ...
xerox 3210 workcentre - ''system error cycle power'' what does it mean/ System error --> software inside the printer has detected some sort of "software" error. Cycle power -> disconnect the AC ...
32 questions posted
Usually answered in minutes!
223 Questions
192 Questions
168 Questions
156 Questions
143 Questions