Consew 206RB "bobbin hooking thread" Questions

...bobbin thread will not raise with the needle 1. REPLACE NEEDLE W/FLAT PART AWAY FROM YOU. 2. MAKE SURE THE TOP THREAD IS PROPERLY THREADED. 3. INSURE BOTTOM BOBBIN IS ROTATING RIGHT DIRECTION. ...

bobbin thread and the thread sometimes breaks Can be several causes. In typical probable order for rotary hook machines; 1.Top thread tension is too high (lower tension) 2.Top thread snagging at spool

...bobbin thread is not hooked. the top thread just tangles on the bobbin race because the loop that is hooked up by the hook does not reach far enough to catch the bobbin thread. 1. There are many ...

...bobbin thread. Something is catching when the needle starts to come up that is not allowing the bobbin thread to be pulled back through the needle plate opening by the upper thread. With machine ...

...bobbin thread, the bobbin should turn counter clockwise. make sure thread is under bobbin case tension spring. With cover plate open hold needle thread and turn hand wheel towards you to see if hook ...

bobbin thread? It wraps the thread around the bobbin and binds the machine up. The shuttle hook is suppose to hook the needle (spool) thread and loops it around the bobbin case to form the lock stitch

bobbin thread i have a e-10 huskystar and i can not get the bobbing thread to connect with the needle thread, help Sounds like hook/needle timing is off. Check it by doing the following with the power

...bobbin thread are not set under the presser foot when starting to sew 6. the threads were not drawn to the rear after sewing 7. The thread is either to heavy or to fine for the needle 8. Try a ...

...bobbin thread pulled up after I dropped it in ), it runs fine. When I put fabric in and begin to sew it makes about 2 stitches then the bobbin thread tangles and forces the whole machine to lock up. ...

...bobbin thread to neddle bobbin thread, all you gonna do is to check the bobbin winding thread if it is in clockwise rotation when you pull out on the bobbins casing, insert the shattle casing, then ...