Question about Fisher and Paykel Washing Machines
balance switch. The out of balance micro switch under the brown motor controller board is corroded and needs replacing. I removed the out of balance switch box and found the yellow and white terminals
...Balance Switch was located below the right hand side of the computer board (module). Rgdz John T F & P Intuitive Eco Washing Machine Code 43. I followed the instructions from of an entry on this site ...
...balance control switch with 1 white and 1 yellow set of wires 5 remove wires ( make note on where they plug back into ) 6 2 small clips hold the switch in place, open them gently and pull switch out ...
...switch, it should be N.C., or normally closed, giving a "balanced" signal back to the control board. My unit had no continuity even when there was no out of balance, or severe shaking. If you have a ...
Question about Washing Machines
...half a minute stane.Tako device twice and disconnect switches to off. MARTIN ARTHUR AWF 1435 I cleaned the filter, centrifuge does not achieve sufficient spins and short runs Check for out of ...
...balance. To get the washer to spin fast like it should I had to open the lid then close it, re-engaging the spin cycle. I opened the top and watched the motor engage in the spin cycle. with the top ...
clean the pump out. Also, on a previous service call the tech was able to empty the water by just entering some combo of keys, if you have access to this info, that would be very helpful. ?Ld? flashes
...balance on the spin cycle is faulty. I have not taken apart yet to have a look but do you have any ideas before I dive in? -thanks Hi, try to check the spring virator support might pollout from slot ...
Question about Fisher and Paykel Washing Machines
...clean tiles underneath. Then it was moved right back. I don't see how this action could have damaged the machine? kr & tia Fault code 43 OOB switch error (out of balance) CHeck Bowl Is Balanced ...
629 questions posted
Usually answered in minutes!
45 Questions