Samson SX1200 Amplifier "protect light blown" Questions

...PROTECT light is still on, then you've blown a fuse (which might be inside the amp) If the PROTECT light does not come on, then check your speaker wiring and speakers. If you have access to different ...

...Protect light on. No blown output transistors. Both chanwnels appear to be good. ie. No blown output transistors, no speaker circuit shorts and nothing gets hot. Anyone have a schematic for this amp? ...

the protection light is flashing on my cambridge audio system. I have turned it on and off Hi... Blown fuse internally or one of the power transistors have failed

...protect mode is normally when there is to much power running to the amp. if a fuse is blown it normally wont turn on. but take your fuses out hold them to a light and you will be able to see through ...

...light !!!! turned it off numerous time etc plenty of venterlation carnt get it to work Looks like the fuse blown.. or the classic symptom of electrical fault inside the amp. 640A uses a sensitive ...

...would suggest you take it to your local Crown repair depot. It sounds like a fault in the internal protection circuits or the outputs are blown. Without a lot more information I cannot

...blown was celestions 400 watts with 4 ohms and one b-52 speaker 300 watts 8 ohms, this ic starting to cost a lot. Turn the volume down? Feed it cleaner source material? ...

protect and peak light are on and won't go off? Please help! Hi There,Manufacturers install protection devices in their audio systems that are there for that purpose, any loud 'thump' or 'crack' trips

...light beside it does come on for about 3 seconds before going out. No sound comes from amp. We recently had a power cut on the national grid and I suspect the amp got damaged then. Can this be fixed? ...

...blown caps c401 an c402 replaced amp comes on but only half the rail volts hum in right channel low output left cannot find colprut can you help thx ed @just-audio.com ive checked everything two red ...