...lamp door is secure. The TV is 3 1/2 months old. Some direction and advice would be appreciated. . Set shuts off after displaying the message "TV will shut down in a few seconds. Please check if the ...
...tv next to ah window..¿what can i do? Check to see if the lamp is on when the unit is off (in standby) if it is components on the Power PWB... 9A20 and/or K9A21 are shorted. Also, R9A02 may be open. ...
...lamp from mitsubishi-tv.com for our WD62327 mitsubishi. we have replaced the lamp, the lamp light on the front panel of tv starts out orange as the power is on. then the lamp light starts flashing ...
Question about Mitsubishi WD Televison & Video
lamp two other times since we purchased the TV in 2006. However, the last two times we had to replace it, the lamp light started with a flashing yellow light and then eventually days later went to red
Question about Mitsubishi WD Televison & Video
...tv , replaced lamp and still no picture I had the lamp go out on my tv , i replaced the lamp and i restarted the tv , it made a sound as if a fan was going , then the noise stopped , the sound was on ...
Question about Mitsubishi WD Televison & Video
...tv with him LOL. Good Day; 1. Check for an open AC fuse F9D00, if open check for a short on the 340v line to the lamp ballast between pin 1 an 5 at connector PL on the Power PCB, if shorted replace ...
...lamp and the light is still on and the picture won't work Good Day; Most likely you have bad caps on the TV's power supply. The following will guide you in the correct direction to properly repair ...
lamp cart and there is i white burn mark in the middle of light. i pluged in tv back in and the red light still comes on. Good Day; Bad news this TV has multi problems, check these: 1. Red status LED,
...lamp came on but when I turned the tv off then on again the red light is out. There is no indication of a lamp problem. Good Day; more like you have a bad lamp, if not try this: 1. Red status LED, ...
tv is on for those few minutes. What can this be? GOOD DAY; THIS COULD BE YOUR PROBLEM: 1. Red status LED, self-diagnosis error 44, check for open F9A06 on the Power PCB part # 283P128050 on the Power
100 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
252 Questions
240 Questions
221 Questions