Connex 3300 240-Channels Base CB Radio "lower swr radio antenna" Questions

Ad

Question about Galaxy Radios Radio Communications

1 Answer

...lower the SWR via the radio. it has to do with the antenna. The length of the antenna is essential to transmitting properly. It must match the transmitting frequency. To check SWR tune to ch 20. Flip ...

Ad

Question about Cobra Radio Communications

2 Answers

swr is lower on 1 than it is on 40 the antenna must be shortened buy 1/4 inch.until you reach your desired swr.if the swr is lower on 40 than it is on 1 the antenna must be lenthened by 1/4 inch until

Ad

Question about Cobra Radio Communications

3 Answers

probably is that your swr's are too high. check them on 1 and 40. use an inline meter, not the radio meter. if your swr's are lower on 1 thean 40, lower the whip. if 40 is lower than 1, raise the whip

Question about Connex Radio Communications

2 Answers

...lower your stinger as far into the antenna as it will go and you need it shorter, you cut the bottom of your stinger no more than 1/2" at a time, and recheck your swr reading after each cut. Once you ...

Question about Connex Radio Communications

3 Answers

...SWR will also be affected by channel. Best if you can further lower it down. 3. some cb cant get me This is because the standard CB radio is only 40 channels. The next would be a 80 channel and then ...

Question about Cobra Radio Communications

2 Answers

SWR reading. The lower the better. Anything under 1.5 is considered really good. But still, the lower the better. Make note of what your SWR was on ch 1. Now flip to channel 40. Repeat the SWR process

Question about Galaxy Radios Radio Communications

2 Answers

...SWR. The lower the better. SWR stands for "Standing Wave Ratio" Or in layman's terms, SWR is energy that is reflected back into the radio. The higher your SWR reading, the more RF energy that is not ...

Question about Cobra Radio Communications

3 Answers

SWR. Ideally it should be 1.5 or lower. Hope this be of some help to your and give you ideas. Good luck and kind regards. Checking and setting the swr can only be accomplished with an inline swr meter

Question about Cobra Radio Communications

1 Answer

lower, then turn the radio back to channel 20 and take an SWR reading. You will now find that the SWR on channel 20 is really low. Most likely under 1.5 or better, Almost nothing on the meter. Here is

Question about Cobra Radio Communications

1 Answer

lower the SWR the better. Here is how to check the swr. Turn to ch 20. Put the sf swr cap switch to CAL. Key the radio. With the radio keyed, turn the cal knob up until the meter is all the way to the

Not finding what you are looking for?
Connex 3300 240-Channels Base CB Radio Logo

226 questions posted

Ask a Question

Usually answered in minutes!

Top Connex Radio Communications Experts

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66949 Answers

Patrick Patterson
Patrick Patterson

Level 1 Expert

6 Answers

Are you a Connex Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...