SWR meter reading will rise, thereby indicating that a problem exists. To calibrate, switch to the "CAL" position, transmit by pressing the mike switch, and adjust the SWR control to the "CAL" mark on
Question about Cobra Radio Communications
...calibrate my SWR to the little diamond shape indicator on the meter and then set my switch to SWR without releasing my microphone button, my SWR is about .5, but when I release my microphone button ...
...SWR is higher on ch 1 then on ch 40 then your antenna is too short. You must lengthen the antenna. Again refer to your antenna instructions on how to lengthen your antenna. You must calibrate each ...
Question about Cobra Radio Communications
swr meter on cobra 29 classic keeps moving while dead keying Why does the swr meter on my cobra 28 ltd classic bounce back and forth while trying to calibrate the meter do you have it on calibrate?
Question about Cobra Radio Communications
...swr or calibrate switch. Turn your RF gain all the way up. There is no need to turn it down. Make sure the squelch is down. Also, some days it's just really quiet out. You can turn the radio on some ...
...calibrate an Aries swr 420 meter for a cb radio To calibrate the meter set the switch to FWD/CAL/REF and key the microphone without speaking into it. then turn the control until the needle is on CAL. ...
Question about Radio Communications
How does a person adjust the swr with the built in swr calibrator You can't adjust the SWR with the built in calibrator. The radio has a built in SWR tester but does not have an antenna tuner. Ideally
Question about Cobra Radio Communications
...calibrate swr and rf meters on 29classic to match extral meter? VR5 tx power meter VR6 antenna warning light There is not pot for swr cal internally. I guess the cal knob broad range pot or variable ...
...Calibrate For SWR (Standing Wave Ratio) http://www.cbtricks.com/radios/cobra/29ltd_bt/graphics/cobra_29ltd_bt_om.pdf The CAL is only to calibrate meter for a swr check of you antenna system it does ...
...swr, and cal (calibrate). Put the switch in the "cal" position. Key the mic and hold it. Turn the SWR calibration knob one way or the other until it lines up with the triangular mark in the upper ...
226 questions posted
Usually answered in minutes!
39 Questions
8 Questions