bad bearing in a model 395 front bearing is locked up on a model 395. were can I a repair shop? threw it in the trash!
Question about Dremel Tools & Hardware - Others
395) needs to be lubricated. It has a squealing sound when turned on which is differnet from its normal sound. What should I use and how. Just a comment-Based on experience, I would go with BOTH their
Question about Dremel Tools & Hardware - Others
...395 was used to cut out drywall, now it does not run.Could dust in the motor be the problem? Tried blowing out the dust from the housing. Drywall dust has ruined your tool. It seizes up bearings and ...
Question about Dremel Tools & Hardware - Others
...395 will only run up to about setting 4... I took it apart, cleaned the switch and still the same problem While it was apart I checked the amature and found it had deep grooves carved intoa number of ...
worn front bearing on Dremel Multipro collett holder appears to be a press fit onto armature shaft, worn bearing is behind holder. How do I remove holder to get to bearing? You can put new grease into
395.. Nylon coupler cracks open whrn I replce it. Two ?'s : How do I order replacement nylon couplers and why do they crack open when I install? I'll answer last question first. They might be cracking
Question about Dremel Tools & Hardware - Others
need to replace DE bearing dremel model 398 go to Http://www.dremel.com/en-us/AttachmentsAndAccessories/Pages/Attachments.aspx
Question about Dremel Tools & Hardware - Others
dremel multipro variable speed only starts in 4 or 5 speed with tool unplugged rotate tool end with your finger tips if it gives any resistance to this your bearings have forign material in them ...
Question about Tools & Hardware - Others
This tool was a hand-me-down, and I assume it's been around for a while, so maybe it's on its way out. Most of the time it runs OK, but occasionally it slows way down when it's turned to 5. I turn it ...
...395 had the same problem so I took it apart. There is a plastic spline between the motor and the output shaft to the chuck . My plastic spline was split and had many of its teeth sheared off. The ...
197 questions posted
Usually answered in minutes!
35 Questions
27 Questions
32 Questions
23 Questions