Seagate Barracuda 7200.10 500 GB SATA Hard Drive "jumper settings slave" Questions

...settings for plastic jumper location is usually printed on the top of a hard drive IDE-0 means Pri master IDE-1 means Pri slave IDE-2 means Sec master IDE-3 means Sec slave single or master ::::: ...

...jumper settings given for all types of settings. there you will fins a setting of the jumper for this drive to be used as a slave. Pullout the jumper from wherever it is and slide it over the pins as ...

how do I set my 7200 Seagate drive as slave Look at the diagram on the drive, you will need a jumper MA = Master SL = Slave CS = Cable Select If it's EIDE use the center connector on the cable

...jumper settings is on the top of the hard drive. 3) Remove plastic tabs and put them according to "Slave" instructions. 4) Connect drive to middle connector of the cord. 5) Connect power supply cord. ...

jumper settings for slave Page 21 in this manual shows the jumper should be removed to set this drive as a slave. You could also position it over the second column of pins, that is the cable select ...

...jumper settings. These jumpers are located near the data cable and the power port of the hard disk. Usually by default, this jumper is set to "Master". To make it a slave, just remove the black or ...

...settings or any other adjustments. for this./......... Hi, In first HDD put the jumper in first vertical pair of pins from power socket side, it will become master and second HDD put jumper in second ...

...jumper settings; I need the correct Pin layout. If I remember correctly then you nee to REMOVE the jumper to have it as a slave drive. Otherwise the second from left (with power plug on the right) is ...

...hardrive you need to set that hardrive jumper into slave format....check your hardisk if where pin should it e placed...usually there is a direction where to set the jumper for slaving the

...please help me out to find a better solution . thanks for providing online help.. Dear Your jumper setting is wrong.your elected is none ata compatible .plz set the jumper setting master or