Intermec EasyCoder PC4 Label Printer "starts printing half down" Questions

...printing out half way on a label that is 1 and a half inches in height and width Your printer is not sensing the gap between two labels.Please try calibrating the printer for the gap. Switch ON the ...

...Printing half a page with an Inkjet machine is not normally a computer issue. So windows 10 would not normally have any effect on the printing for a printer that has been accepted by the Windows 10 ...

...printing labels on zebra TLP2844, we are losing half of top line. any clues? How can we adjust the gap from top of a label to where it should starts to print? Label definition in printer driver may ...

...half missing when printing a solid block of magenta. Help! This is the 5th printer between my mom and I that has had problems with the magenta! you guys are a joke! I thought that you really did want ...

...the half top Try recalibrating by holding down the button on powerup.  When the label starts to move let go.  After it prints the diag page hit the button once to take it out of "dump

lines. Run a half test. Start printing a few pages, as it prints open the cover, remove the toner and look down at the paper. Does it have lines on the right side? If yes - replace the toner cartridge

...printing,bottom half prints top half is white. Any suggestions I have the same problem where only the bottom half of my photo prints. It worked fine for a long time. I even tried flashing the printer ...

...half-used, and was not printing well, so I took out the cartridge and shook it and put it back in. However, this is when it started showing it was full, even thought it's half-full or a little less. ...

Printing Issue Hi there, I have a Kyocera FS-1000 and the other day it decided to print very slowly and at that decieded to print some pages of print starting half way down the paper and also printed ...

...printing some pictures when it stopped and only printed half of a picture. I checked the stauess of the printer and it said there was an error. I tried to cancel/delete the printing but it has done ...