Question about Bissell Vacuums
...the brush of the bissell ProHeat i'm trying to install a new belt , but when i'm put back the brush it will com down, and the brush only when it is upright need to install belts need to install ...
...new belt installed. Belt is generic but supposedly is right for this model. Generic bought at Walmart) No noice when run without belt and roller in place. Anyone have trouble with generic belts? what ...
...new belt has no effect. The belt will stay on with the handle in the upright position. Once the handle in lowered and the brush is in contact with the carpet the belt comes off. What makes the belt ...
install a new 4476 belt A burning rubber smell tells me my vac ate the belt. I can't open the vac to install a new belt. What kind of vacuum is it you have? This must be an Eureka vacuum, On the top ...
...install new belt (with lettering on outside of belt), slide back of belt over pulley and pull front of belt toward groove next to pulley. Belt will ?pop? into place. Flat Belt: What to Buy Use only ...
...new belt on it. Improper installation of belt can result in a loose or off center belt which will flap and make lots of noise. It can also result in the burning rubber smell. The belt is probably ...
...new belts, # 38528034, and # 38528-035 There is so much slack in belt # 3852034 (brush drive) that it cannot grip the brush. There does not seem to be any adjustment to take up the slack. I've put in ...
Install new belt. You'll have to remove the botton cover and the remove the brush cylinder and install new bell. What happen when the brush cylinder stop because of the colth belt, it stripped the
install the new belt, then take a belt puller or a screwdriver with a left or right hand hook to use as a belt puller and then stretch the belt onto the motor pulley, then take and roll the belt until
Question about Vacuums
new belt sold to me for model 116 , belt #20-40111 seems too small, is this possible? Sorry, posted in wrong section - the belt in question is for a kenmore evo vacuum. Yes. Models and part numbers ...
542 questions posted
Usually answered in minutes!
390 Questions
261 Questions
302 Questions
244 Questions