Hawking Wireless-G HWR54G (603992506064) 802.11b/g Wireless Access Point "factory reset router" Questions

reset to factory default? Hi nbergma, To Factory reset your router you need to locate the Reset Button at the back of the router. The Reset Button is the small hole at the back and you need a Pen or a

...reset router to factory settings by pressing the reset button on the back side of the router. Press the button for a few seconds, the lights on the front would blink and the router would restart with ...

...factory reset it. Locate the reset button on the back and while plugged in, press and hold the reset button for 10 to 15 seconds. After you release the reset button the router will reboot to factory ...

...device is reset to factory defaults, you can use the default username ("admin") and password (either "password" or "1234" depending on your router) to reconfigure your router settings. hope this ...

...reset to factory defaults but it won't take Try This:1 Unplug all cables from the router except the power cable. Power on the router.2 Locate the reset button. This is typically a small hole ...

reset the router to factory default setting, press and hold the reset button for few seconds (It is at the back of the router on the right hand side to the DC Power Jack). The LEDs will then blink and

reset device to factory default In order to get your router back to the original settings, you must push in the reset button (usually on the back of the router) for somewhere between 10 and 30 seconds

How do I reset my cisco password? Find the reset button on the router, then hold it down for around 30 seconds to a minute. This should reset the router to factory default settings.

factory reset on OM1P ? there is a reset switch hole at the bottom of open mesh router just push with toothpick and hold for 30 second the all lights goose off now the router on reset mood release the

...reset the router to factory settings. It might have a piece of tape over the whole.Below are the steps on how to reset a Linkys Router to factory default. Click ...